Roll Former Machine

Roll Former MachineZLTFM25-205-820
Introduction
Model Wall and Roofing Colored Steel Cold Roll Forming Machine consists of uncoiler and its base, coil sheet guiding equipment, film covered device, roll forming system, post-cutting equipment, hydraulic station, controlling system, supporter table.
Technical Parameters
Material Spec	Colored steel sheet / galvanized steel sheet
Thickness of Coil Sheet	0.3 --0.7 mm
Main Motor Power	7.5kw
Forming Speed	8--10m/min
Hydraulic Station Power	3kw
Quantity of Stands	About 18 groups
Hydraulic Pressure	10~12Mpa
Controlling System	PLC
Index Error of Length	10m±2mm
Total Weight	About 1000kg
Voltage	380V 3 phase 60Hz or to the buyer's requirement
Material of Main Equipment
Roller Material	high grade No.45 forged steel, plated hard chrome on the surface of roller with thickness 0.05mm
Active Shaft Material	high grade No.45 carbon wrought steel at Φ 75mm.
Cutter Blade	Cr12 mould steel with quenched treatment.
Electric Elements	Control system with PLC model S7-200, Siemins.transducer with ABB control panel with TP170, Siemens. It can input 10sets of spec at one time
Oil Tank Model	CB-E310
Component and Function
1. Sheet guiding equipment: Using guiding equipment of leader sliding block style. The width and the left or right position can be adjusted only by adjusting the leader, then the sliding block can realize left or right movement.
2. Mainframe Transmission: Transfer the main motor power to the rollers through chains and sprockets, and also transfer the coil sheet.
3. Roll forming system: The main frame of machine is welded separately and the outside wall is connected by screw after being roto-blasted on the surface. The rollers are surface-chrome plated after being machined by the exact machine tool..
Designated use
1. Some final products for Automobile.
2. Some final products for Building, such as for Roofing / Ceiling / Wall materials, and dry wall (track and stud) material.
3. Some final products for Gate-Panel, Guard-Panel and sound insulation